Comprehensive rebuild kit for Holley 5200C carburetors used on 4 cylinder and V-6 engines from 1972 to 1978. This is the Holley-Weber carburetor, which is a small, progressive two barrel carburetor built under license by Holley and based on a Weber design. It is most commonly seen in this version on Ford Pintos up to 1978. Later versions of this carb used a different kits (see our Ford listings).
This kit features all ethanol friendly components shown in the picture, including the internal gaskets, needle/seat, accelerator pump diaphragm assembly, choke pull down diaphragm, power valve actuator, flange (mounting) gasket, air cleaner gasket, clips and seals + actual printed instructions with an exploded diagram and spec sheet. Made in USA.
List of additional parts that go with this carb kit
Parts listed here may not fit all applications. Check carburetor number listings before ordering parts.
List of vehicle applications that ck7080 fits
Always check carburetor number to make final fitment determination.
1971-1978 Ford Pinto, Mustang, Mercury Bobcat, Capri with 2.0L & 2.3L 4 cylinder
1972-1976 Ford, Mercury 2.6L, 2.8L V-6
Picture of typical carburetor serviced with ck7080
